• Windows 2000, XP, Vista, or Windows 7 with the.NET 2.0 or greater runtimes • An available serial port (com port), USB to serial port adapter or USB port (If the USB Serial adapter will allow you to connect to the panel with DL900, NX-Unlocker should work) The following USB Serial Adapter has been tested and work from Win98 SE to Win7 x64 Keyspan USA-19HS • A CaddX NetworkX Quicklink Direct Connect (NX-586E) or (NX-588E) • DL900 Download Software • CaddX NetworkX NX series panels (NX-4, NX-4 v2, NX-6, NX-6 v2, NX-8, NX-8 v2, NX-8e). Attach the NX-586E to a free com port on your computer (or to a USB Serial Adapter) and the panel to unlock following the directions that came with the NX-586E. (the panel must be powered to work) The comm port settings should be: A. Bits Per Second = 9600 B. Data Bits = 8 C.

This is the GE NX-588E USB Flash Programmer Installation. Program your NX-588E so the settings you choose in the DL900 software download onto your NX.

Parity = None D. Stop Bits = 1 E.

Flow Control = None *steps 2 and 3 are optional but necessary to ensure that your computer is able to communicate with the panel and the panel responds properly* 2. Attempt a direct connect with the panel using DL900 with any access code. You will receive the following error “Incorrect control access code!” If you do not receive this error, your DL900 software is not configured properly for direct access. Consult the DL900 software for help setting up your software.

Close DL900 4. Launch NX Unlocker 5. Select the com port the NX-586E is attached to 6. Click the Reset Access Codes button 7. Wait a few seconds and read the results. If the panel is unlocked, NX Unlocker will tell you.

If it is not unlocked, a message will be displayed telling you why it was not unlocked. Advantage Of Serial Dilution Agar Plate Method. Manual Logitech Keyboard Ipad.

Contents • • • • To connect the [] to the LinuxMCE system, you need a RS-232, P-0003 straight-through serial cable that will connect to the serial header on the NX-8E main board. You can get this cable from computer or electronics stores.

Make sure that the part that connects to the alarm panel's header does not have a plastic block on the last pin (slot #10 - this is unused in a 9-pin connector), otherwise it will not fit into the board. You will also need the to connect the alarm panel to the network unless you plan on connecting it directly to a serial port on the core. --still trying to get the alarm panel to work so if anyone has LinuxMCE configuration help, please include it here.-- The following information about configuring the NX-8E panel came from: Serial Port Wiring This has been tested with a 10-pin to DB9 serial cable, straight through serial cable, and gender changer.